NAS RAID / ZFS Pool Usable Capacity & Rebuild Risk Calculator

Verified Nov 14, 2026 Quality 100/100 Confidence 96% 0 Evaluations
VERIFIED QUICK ANSWER

Eight 16 TB drives yield 128 TB raw (116.4 TiB binary), giving 87.3 TiB raw usable under RAID 6 / RAID-Z2, or ~69.8 TiB practical capacity once keeping ZFS below its recommended 80% fragmentation threshold; single-parity RAID 5/Z1 carries elevated URE rebuild risk above 40 TB.

Interactive Parameters & Live Verdict

Rule Diagnostics & Recommendations

    Engineering Formula & Verification Notes

    Converts manufacturer decimal TB (10^12 bytes) to binary TiB (2^40 bytes, factor 0.90949), subtracts parity drives, and applies either OpenZFS 80% safe fill limit (to avoid copy-on-write fragmentation) or 4% standard filesystem metadata overhead.

    Worked Example: 8x 16 TB Drives in OpenZFS RAID-Z2

    Eight 16 TB decimal drives equal 116.4 TiB binary raw capacity. Subtracting 2 parity drives leaves 87.3 TiB raw usable; capping pool utilization at 80% for healthy ZFS copy-on-write allocation leaves ~69.8 TiB practical storage.

    • Keep ZFS datasets under 80% used to prevent severe fragmentation and slow scrub times.
    • Prefer RAID-Z2 over RAID-Z1 whenever individual drive sizes exceed 8–10 TB.

    Common NAS Array Planning Mistakes

    Assuming decimal TB equals binary TiB leads to ~9% unexpected capacity shortfall right after formatting.

    • Choosing SMR (Shingled Magnetic Recording) drives in ZFS pools, which cause massive resilver timeouts.
    • Relying on RAID redundancy as a substitute for offline/offsite backups.

    Parity Tradeoffs for 8x 16TB Drives

    Parity Tradeoffs for 8x 16TB Drives
    Topology Fault Tolerance Net ZFS Safe TiB
    RAID-Z1 (1 parity) 1 drive failure 81.5 TiB
    RAID-Z2 (2 parity) 2 drive failures 69.8 TiB
    RAID-Z3 (3 parity) 3 drive failures 58.2 TiB

    Frequently Asked Technical Questions

    Why does a 16 TB drive show up as 14.55 TiB?

    Drive makers use decimal terabytes (1,000^4 bytes) while operating systems report binary tebibytes (1,024^4 bytes).

    Why keep ZFS pools under 80% capacity?

    Copy-on-write filesystems suffer severe write amplification and space-map fragmentation once free contiguous blocks drop below ~20%.

    Is ECC RAM required for ZFS?

    ZFS works without ECC, though ECC RAM prevents silent memory bit flips before checksums are computed.

    Did this interactive specification answer your scenario accurately?