Custom Loop Tubing & Compression Fitting Compatibility Checker
For soft tubing custom loops, both inner diameter (ID) and outer diameter (OD) must match the compression fitting exactly. For hard tubing, only the outer diameter (OD) matters as it seals against internal O-rings; the inner diameter is irrelevant to fitting compatibility.
Interactive Parameters & Live Verdict
Rule Diagnostics & Recommendations
Engineering Formula & Verification Notes
This compatibility checker evaluates PC water cooling dimensions based on industry standards. Soft tubing compression fittings require both exact inner diameter (ID) to fit the internal barb and exact outer diameter (OD) for the locking collar to clamp securely. Rigid hard tubing compression fittings seal via internal O-rings against the outer wall, meaning only the OD needs to match while the ID is irrelevant to sealing.
Worked Engineering Example
When planning a custom loop with 16/10mm soft tubing (10mm inner diameter, 16mm outer diameter), you must purchase 16/10mm compression fittings. If you attempt to pair 16/10mm tubing with a 13/10mm fitting, the inner barb might insert, but the outer locking collar will fail to secure the outer wall correctly, leading to leaks or tube slip under pressure.
- Always verify tubing spec sheets for true metric or imperial conversions (e.g., 3/8" ID x 5/8" OD equals roughly 10/16mm).
- G1/4 threads screw into blocks and radiators universally; tubing dimensions only dictate the fitting-to-tube side.
Common Sizing & Compatibility Mistakes
Builders frequently confuse G1/4 thread specs with tubing dimensions, or assume hard tubing inner diameters matter for compression seals. Hardline fittings use O-rings compressed against the tube exterior, making wall thickness variations irrelevant to fitting fitment.
- Mixing imperial and metric soft tube fittings and tubing without checking exact decimal millimeter equivalents.
- Failing to push soft tubing completely over the barb ridge before tightening the compression collar.
Common Water Cooling Tubing and Fitting Standards
| Tubing Type | Critical Dimensions | Fitting Requirement |
|---|---|---|
| Soft Tubing (16/10mm) | 10mm ID / 16mm OD | 16/10mm Compression Fitting |
| Soft Tubing (13/10mm) | 10mm ID / 13mm OD | 13/10mm Compression Fitting |
| Hard Tubing (16mm OD) | Any ID / 16mm OD | 16mm Hardline Compression Fitting |
Frequently Asked Technical Questions
Do G1/4 threads affect tubing selection?
No. G1/4 is the standardized threading on water blocks, pumps, and radiators that attaches the base of the fitting. Tubing dimensions only dictate the other end of the fitting.
Why does hard tubing inner diameter not matter?
Hard tubing seals via internal O-rings that press directly against the outer diameter (OD) of the tube. The inner wall thickness plays no role in compression retention.
Can I mix different brands of fittings and tubing?
Yes, provided the nominal metric or imperial measurements match down to the millimeter or fraction of an inch. Always cross-check stated tolerances.