EV Dual Charger Dynamic Load Sharing Calculator

Verified Nov 21, 2026 Quality 100/100 Confidence 85% 0 Evaluations
VERIFIED QUICK ANSWER

Dynamic load sharing allows multiple EV chargers to operate within a fixed subpanel capacity by dynamically allocating current based on individual charging session needs. The system calculates available current (subpanel capacity minus existing load) and distributes it among active chargers, respecting individual charger limits (typically 6A minimum per phase). When a Power Control System (PCS) is installed per NEC 625.42, load calculations can use the limited load value rather than full equipment ratings. Each charger's circuit breaker must be sized at 125% of its maximum current due to continuous load requirements.

Interactive Parameters & Live Verdict

Rule Diagnostics & Recommendations

    Engineering Formula & Verification Notes

    Calculations assume a Power Control System (PCS) as defined in NEC 625.42. Available current is derived by subtracting existing demand from the subpanel rating. Per-charger allocation assumes equal distribution.

    Worked Engineering Example

    A 100A subpanel with 40A of existing load leaves 60A for EV charging. With two chargers, each receives 30A. If one car stops, the other can dynamically scale up to the full 60A (or its internal charger limit).

    • Always verify continuous load (125%) requirements.
    • PCS allows for smaller breaker sizing than static loads.

    Common Sizing & Compatibility Mistakes

    Engineers often forget that EV chargers are continuous loads. Failing to account for the 125% rule or assuming all chargers can operate at max capacity simultaneously leads to nuisance tripping.

    • Ignoring the 6A minimum threshold for EVSE.
    • Confusing charger output settings with circuit breaker ratings.

    Reference Benchmarks

    Reference Benchmarks
    Scenario Available Current Per Charger (2 units)
    Standard 100A 60A 30A
    Upgraded 125A 85A 42.5A
    Max 200A 160A 80A

    Frequently Asked Technical Questions

    What is the minimum current for an EV charger?

    Most EVSE units require at least 6A per phase to maintain a charging session.

    Does NEC 625.42 allow for reduced load calculations?

    Yes, if a Power Control System is installed, you can use the limited load value instead of the full equipment rating.

    How does dynamic load sharing work?

    The system monitors total current and throttles individual chargers to ensure the aggregate load does not exceed the subpanel's capacity.

    Did this interactive specification answer your scenario accurately?