Generator-Inverter Compatibility & Sizing Calculator
To ensure compatibility, your generator should maintain <3% THD for sensitive electronics. For safe operation, set your inverter's AC input current limit to floor((Generator Rated Power × 0.80 / Voltage) - (AC Load Power / Voltage)). Always maintain a 20% thermal headroom for continuous charging. Account for inverter efficiency (~92%) and power factor (~0.98) when calculating required AC input power, and ensure your generator can maintain stable peak voltage under load for inductive battery charger loads.
Interactive Parameters & Live Verdict
Rule Diagnostics & Recommendations
Engineering Formula & Verification Notes
Calculations assume a 0.8 power factor derating for continuous generator operation and a 20% thermal safety margin as per standard alternator sizing practices.
Worked Engineering Example
For a 5000W generator at 240V with 1000W of background AC loads:
- Safe continuous capacity: 5000W * 0.8 = 4000W
- Current available for charger: (4000W - 1000W) / 240V = 12.5A
- Recommended setting: 12A (rounded down to ensure stability)
Common Sizing & Compatibility Mistakes
Engineers often overlook the interaction between harmonic current and system impedance.
- Ignoring peak voltage requirements: Inverters need stable peak voltage, not just average RMS.
- Neglecting THD: High THD causes 'repetitive distortion' that triggers inverter fault codes.
- Failure to derate: Running generators at 100% capacity leads to stator insulation degradation.
Generator Quality Benchmarks
| Generator Type | THD Level | Compatibility |
|---|---|---|
| Inverter Generator | <3% | Excellent |
| AVR Conventional | 5-8% | Good |
| Standard Brushless | >10% | Poor |
Frequently Asked Technical Questions
Why does my inverter report a voltage error?
Likely due to high THD causing voltage spikes or waveform distortion that the inverter's sensing circuit rejects.
What is the importance of the AC input limit?
It prevents the inverter-charger from drawing more current than the generator can provide, which would otherwise cause the generator to stall or the breaker to trip.
Does power factor matter?
Yes, chargers are often inductive loads (PF ~0.7). Using VA instead of Watts for sizing ensures you don't overload the alternator.