SFX PSU Cable Length & Case Clearance Planner

Verified Nov 15, 2026 Quality 100/100 Confidence 100% 0 Evaluations
VERIFIED QUICK ANSWER

SFX power supplies feature standard 100mm lengths (or 130mm for SFX-L) and shorter stock cables (typically 300mm-350mm for 24-pin). Ensure a minimum of 25mm to 35mm rear bend clearance for cables and connectors to prevent installation failures in SFF chassis.

Interactive Parameters & Live Verdict

Rule Diagnostics & Recommendations

    Engineering Formula & Verification Notes

    Calculations evaluate physical depth stacking by summing the rigid PSU enclosure length (100mm for SFX, 130mm for SFX-L) with mandatory connector/bend allowances (25mm standard, 35mm for 12VHPWR). Cable reach compares routing spans against baseline stock SFF 24-pin lengths (300mm).

    Worked Engineering Example

    Consider building in a compact SFF chassis with a 135mm PSU chamber depth using an SFX-L power supply (130mm length) and a 12VHPWR GPU connector. Total required depth equals 130mm + 35mm (bend allowance) = 165mm. Comparing this against the 135mm available yields a -30mm deficit, confirming the hardware combination is incompatible without modifications.

    • SFX-L depth: 130mm
    • 12VHPWR bend radius requirement: 35mm
    • Resulting deficit: -30mm (Incompatible)

    Common Sizing & Compatibility Mistakes

    Builders frequently assume that matching the exact millimeter dimension of the PSU body to the case specification is sufficient. However, modular connector blocks, rigid wire harnesses, and AC input plugs require physical breathing room.

    • Failing to account for the 25mm to 35mm connector protrusion and wire curvature.
    • Using stock SFX cables in custom Mid-Tower layouts where 300mm lengths fall short of reaching motherboard headers.
    • Overlooking interference between long power supplies and front-mounted drive cages or liquid cooling radiators.

    SFF Form Factor Reference Matrix

    SFF Form Factor Reference Matrix
    Form Factor Dimensions (W x H x D) Typical Stock 24-Pin Min Bend Clearance
    Standard SFX 125 x 63.5 x 100 mm 300 - 350 mm 25 mm
    SFX-L 125 x 63.5 x 130 mm 300 - 350 mm 25 mm
    Standard ATX 150 x 86 x 140+ mm 610 mm 35+ mm

    Frequently Asked Technical Questions

    Why are SFX power supply cables shorter than ATX cables?

    SFX PSUs are built specifically for small form factor cases where excess cable length is cumbersome and difficult to manage. Stock 24-pin cables typically measure 300mm to 350mm compared to 610mm on ATX units.

    Can I use an SFX power supply in a standard ATX mid-tower case?

    Yes, using an SFX-to-ATX adapter bracket is physically possible, but the stock cables will likely be too short to reach motherboard headers across standard or large chassis layouts.

    How much space should I leave behind an SFX power supply?

    Always leave a minimum of 25mm for standard high-gauge wiring and at least 35mm if you are utilizing stiff 12VHPWR or 12V-2x6 cables to prevent dangerous bending stress.

    Did this interactive specification answer your scenario accurately?