Victron VE.Bus BMS Relay Interlock & Generator Auto-Start Calculator

Verified Nov 22, 2026 Quality 100/100 Confidence 100% 0 Evaluations
VERIFIED QUICK ANSWER

Verify Victron VE.Bus BMS V2 and MultiPlus/Quattro compatibility, check microprocessor limits (avoid 19XXXXX/20XXXXX), firmware version thresholds (>=xxxx415), and GX Relay 1 auto-start trigger voltages.

Interactive Parameters & Live Verdict

Rule Diagnostics & Recommendations

    Engineering Formula & Verification Notes

    Calculations evaluate VE.Bus hardware processor prefixes, firmware version hurdles against the xxxx415 minimum required for BMS V2 integration, and verifies GX Relay 1 automatic generator start (AGS) voltage parameters.

    Worked Engineering Example

    Consider a 24V Victron MultiPlus-II system paired with a VE.Bus BMS V2 and a Cerbo GX for automated generator control. The technician inspects the MultiPlus microprocessor sticker and confirms prefix 26XXXXX (compatible), and updates firmware to xxxx420 (passing the xxxx415 requirement). For reliable auto-start, Relay 1 on the Cerbo GX is configured for AGS, with a start trigger set at 22.0V and a clear voltage threshold calculated at 26.8V.

    • Microprocessor prefix 26XXXXX avoids the 19XXXXX/20XXXXX limitation.
    • Firmware version 420 prevents VE.Bus Error 15 combination faults.
    • Relay 1 provides potential-free dry contact closure for generator remote start.

    Common Sizing & Compatibility Mistakes

    Deploying multi-unit VE.Bus setups requires exact 4-digit compatibility ID matches on device stickers. Furthermore, relying on GX Relay 2 for auto-start is a frequent installation error—only Relay 1 on the GX device supports built-in AGS functionality.

    • Using Relay 2 instead of Relay 1 for generator auto-start commands.
    • Failing to account for voltage drop across long generator control wire runs.
    • Mixing devices with differing 4-digit compatibility IDs in parallel or split-phase arrays.

    Victron Generator Integration Reference Benchmarks

    Victron Generator Integration Reference Benchmarks
    System Configuration Required Relay Min Firmware / Processor
    Cerbo GX AGS Relay 1 Only Venus OS v2.80+
    VE.Bus BMS V2 Charge / Load Disconnect Firmware >= xxxx415
    MultiPlus Virtual Switch K1 / K2 Auxiliary VE.Bus Assistant Configured

    Frequently Asked Technical Questions

    Can Relay 2 on the Cerbo GX be used for Auto Generator Start?

    No. Relay 1 is specifically designated for generator start/stop functionality in the GX device menu. Relay 2 does not feature the built-in AGS automation software.

    What causes VE.Bus Error 15 when installing a VE.Bus BMS V2?

    Error 15 is a VE.Bus combination error triggered when connected devices run firmware versions below xxxx415. Updating all connected units resolves the issue.

    How does the VE.Bus BMS V2 keep the Multi in low power mode?

    The BMS V2 maintains a connection to the battery positive terminal, allowing it to signal the inverter/charger into low power mode even when AC input is available.

    Did this interactive specification answer your scenario accurately?